Universal Tubs HDSI3060RWS Installation Guide download pdf (Page 8)

Universal Walk-In Bathtubs 5701 NW 35 Avenue Miami, FL 33142 PHONE: 877-360-4454 FAX: 866-560-1060 www.universaltubs.com

Page 6

SAFETY

PRE-INSTALLATION*

* All Walk-In Bath Tubs are 100% water tested at the factory certified to be free of leaks. Transportation and mishandling may cause leaks. It is necessary to test the bathtub while there is access to

all sides of the bathtub.

READ AND FOLLOW ALL INSTRUCTIONS

• Place the tub on a completely flat surface in an area where it may be drained after testing.

• Close the drain and fill the tub until it is above the highest jet. If it’s a soaker fill up to normal water height level.

• Allow the water to stand in tub for 30 minutes and then inspect all plumbing and seals for leaks.

• If tub is jetted, supply electric to unit and run for 10 minutes and inspect for leaks. Inspect the unions around the pump; if leaks

persist from the unions after tightening; loosen the unions and insure the O-ring is seated properly.

NOTE: IF THE PUMPS DO NOT OPERATE, CHECK THE BREAKER TO ENSURE POWER IS ON AND THE CABLE CONNECTING THE

CONTROLS TO THE PUMP IS ATTACHED.

WARNING! DO NOT RUN ANY PUMPS UNLESS THE TUB IS FILLED WITH WATER TO PROPER

LEVEL. DAMAGE DUE TO DRY RUNNING PUMPS IS NOT COVERED UNDER WARRANTY. FAILURE TO

PERFORM THESE TESTS BEFORE INSTALLATION WILL MAKE THE INSTALLER LIABLE FOR FUTURE

REPAIR COSTS.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Comments to this Manuals

No comments

Universal Tubs HDSI3060RWS Installation Guide Page 8

Comments to this Manuals