Universal Tubs HDSI3060RWS Installation Guide download pdf (Page 11)

Universal Walk-In Bathtubs 5701 NW 35 Avenue Miami, FL 33142 PHONE: 877-360-4454 FAX: 866-560-1060 www.universaltubs.com

Page 9

OPERATING INSTRUCTIONS

INSTALLATION PROCEDURES

WARNING! WHEN INSTALLING JET MASSAGE BATH, THE FOLLOWING BASIC PRECAUTIONS

SHOULD BE FOLLOWED.

DANGER! RISK OF ELECTRIC SHOCK. CONNECT ONLY TO SEPARATE CIRCUIT PROTECTED BY A

GROUND FAULT CIRCUIT INTERRUPTER (GFCI) ON PLUG IN UNITS.

NOTE: INSTALLATION MUST PROVIDE ACCESS FOR SERVICING PUMP/MOTOR (ALL TUBS COME WITH AN ACCESS PANEL

FOR THE PUMP/MOTOR).

GENERAL GUIDE-THROUGH

• Install tub waste/overflow according to instructions (see page 10).

• Standard installation - After framing is a complete (see attached diagrams), set product in place to make certain that the tub can

be properly leveled. (Caution: If a walk-in bathtub is not resting on all leveling feet, water will not drain properly and may cause

the door to leak) (see page 7).

• Verify the product’s level by checking tub’s deck surface and ensure all leveling feet are touching the ground (see page 7).

• Electrical connection is made pre-instruction on specified models.

• After plumbing and electrical connections have been made, the tub should be cleaned of dirt and debris.

• Installation is not complete until the tub has been tested in place.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

No comments

Universal Tubs HDSI3060RWS Installation Guide Page 11